Desco 19337 - Multi-Mount Continuous Monitor w/Universal Plug

• Single Workstation Continuous Monitor
  Continuously monitors the path-to-ground integrity of one operator and one ESD worksurface
• NEW Park Delay Timer and ParkSnap™
  Indicates the 8 second delay to disconnect and park the operator wrist cord without creating a false alarm
• NEW Light Tower Compatibility
  Connects with the 19332 Light Tower accessory
• Wave Distortion Technology
  Provides stable continuous monitoring (versus pulsed or intermittent) of the wrist strap’s path-to-ground* and the presence of its 1 megohm safety resistor
• Mat Monitor Switch
  Disables the worksurface monitor circuit when used in areas where there is no ESD worksurface
• Audible Alarm Adjustment
  Sets the audible alarm volume from loud to louder
• Enclosure with Mounting Tabs
  Installs in workbench and equipment environments
• Single-Wire Impedance Design
  Meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-0
• 1.2 Volt Operator Test Voltage
  Reduces the risk of electrical overstress (EOS) for the handling of sensitive components
• <50 Millisecond Alarm Response Time
  Identifies failures and intermittencies
• Calibration Verification
  Use the DDesco 98221 Wave Distortion Monitor Verification Tester
• to check the test limits of Wave Distortion Monitors without removing them from their workstations
• NIST Calibrated – 
  Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology. For more information on the calibration of Desco products, see Calibration.
• 100-240VAC Power Adapter with IEC C14 Style Inlet
  Connects to a power cord with a IEC C13 outlet connector
• Made in the United States of America
  This item is made and stocked in Chino, CA

*The ESDA Wrist Strap standard is ANSI/ESD S1.1. The Wrist Strap System required limit per ANSI/ESD S20.20 Table 3 is 0.8 to 1.2 x 10⁶ ohms with product qualification testing per ANSI/ESD S1.1. The test range of the monitored circuit is 500 kilohms to 10 megohms.