On The Cutting Edge with Tronex Cutters

Semi-Flush cutting edges feature a small edge bevel on the cutter and are typically used in an industrial setting to cut thicker wire and leads. Semi-Flush edges will leave a “pinch” in the middle of the end of material being cut. These cutting edges will be the most durable, the most cost effective, and most resistant to dulling, extending the life of the tool.

Flush cutting edges feature a very thin edge bevel on the cutter that leaves only an exceptionally small “pinch” in the middle of the end of the material being cut. Flush edges are used in a wide range of electronics manufacturing applications where users are looking for a balance between longevity, precision, and cost. These Flush cutters are versatile, widely used, and a Tronex best seller.

Razor Flush® cutting edges feature no bevel on the cutters. This results in exceptionally sharp edges which produce cuts leaving virtually no raised surface or “pinch” on the end of the material being cut. The cutter actually operates like two razor blades coming together. Razor Flush® edge cutters are typically used when the highest level of precision is required working with small and/or very fine components. Although more frequent sharpening is required with Razor Flush® cutters, each cutter has a fine set screw stop built into the jaw of the cutter to protect the edges. The Razor Flush® edge finish on Tronex cutters is a proprietary process and the result is unmatched by any other precision cutting tool.